戶外木材應在戶外陰干到與外界環境的濕度大體相同的程度再施工。使用含水量很大的木材施工安裝后會出現較大的變形和開裂。下面
濟南防腐木的小編就給大家總結一下防腐木平臺的施工安裝注意事項，希望那個對大家有所幫助！
Outdoor timber should be dried in shade to the same degree of humidity as the outside environment before construction. Large deformation and cracking will occur after construction and installation of wood with large water content. Next, Jinan anti-corrosive wood Xiaobian summarizes the construction and installation of anti-corrosive wood platform matters needing attention, I hope that will help you!
1、在施工現場，防腐木材應通風存放，應盡可能的避免太陽暴曬。
1. In the construction site, the preservative wood should be stored by ventilation, and the sun exposure should be avoided as far as possible.
2、在施工現場，應盡可能使用防腐木材現有尺寸，如需現場加工，應使用相應的防腐劑充分涂刷所有切口及孔洞，以保證防腐木材的使用壽命。
2. In the construction site, the existing size of preservative wood should be used as far as possible. If field processing is needed, the corresponding preservatives should be used to fully brush all incisions and holes to ensure the service life of preservative wood.
3、在搭建露臺時盡量使用長木板減少接頭，以求美觀；板面之間留5mm—10mm縫隙。
3. Use long boards to reduce joints as much as possible when building balconies in order to be beautiful. Leave 5-10 mm gaps between the boards.
4、木龍骨一定要防腐，相鄰龍骨間距與平臺板厚成正比，但以不超過１米為宜。
4. Wood keel must be anticorrosive. The distance between adjacent keels is proportional to the thickness of the platform plate, but it is better not to exceed 1 meter.
5、安裝固定龍骨在基礎必須打水平，保證安裝后整個平臺水平面高度一致。
5. Installation of fixed keel in the foundation must be level, to ensure that the whole platform after installation level is consistent.
6、平臺板與木龍骨聯接，每塊板與龍骨接觸處需用兩顆釘。所有的連接應使用鍍鋅連接件或不銹鋼連接件及五金制品， 以抗腐蝕，絕對不能使用不同金屬件，否則很快會生銹。
6. Platform board is connected with wooden keel. Two nails are needed at the contact point between each board and keel. All joints should be galvanized or stainless steel joints and hardware products to resist corrosion. Never use different metal parts, otherwise they will rust soon.
7、平臺安裝完成后，為了保護板面清潔美觀，宜用木油（有透明和有色之分）涂刷表面，而不能按照常規油漆涂刷。木油可以在木器表面加上一層保護膜，使其可以達到防水，防起泡，防起皮和防紫外線的作用．讓您不再有木器變舊，變臟，不易清洗等煩惱！
7. After the installation of the platform, in order to protect the clean and beautiful surface of the board, it is advisable to use wood oil (transparent and colored) to paint the surface, instead of conventional paint. Wood oil can be added with a protective film on the surface of wood, so that it can achieve waterproof, anti-foaming, anti-skin and anti-ultraviolet effect. Let you no longer have the trouble of wood getting old, dirty, difficult to clean and so on!
Thank you for your reading, today's content will be introduced to you. Jinan Antiseptic Wood Editor recommends that you collect our official website: http://www.missoularedtape.com, we will regularly release more relevant information!
傳真：0531-86370030
