對防腐木常用涂蠟方法做保護,涂蠟要掌握掌握正確的方法,以取得較佳的效果。涂料不能混用,并不得在防腐木涼亭上面罩面漆或作為底涂使用。刷涂不宜超過二遍。疏水效果在表干后即能見效;刷涂時的硬度增強大概要半個月左右,擦涂硬度增強要3-4天。被涂防腐木表面如有舊油漆一定要去除干凈。用于戶外的話,可先使用耐候木油。
In order to protect the antiseptic wood, we should master the correct method to get better effect. The coatings shall not be mixed, and shall not be used as topcoat or primer on the anticorrosive wood Pavilion. Brushing should not be more than twice. The hydrophobic effect can take effect after the surface is dry; it takes about half a month to enhance the hardness when brushing, and 3-4 days to enhance the hardness when wiping. If there is old paint on the surface of anticorrosive wood, it must be removed. For outdoor use, you can use weathering wood oil first.
還有要注意的是,在20度的中等空氣濕度下對防腐木產品進行涂蠟處理時,約4小時表干,12小時后可重涂,15小時后實干;含油脂較重的木材,溫度低,潮濕時,干燥時間延長。
In addition, it should be noted that when waxing wood products at 20 degrees of moderate air humidity, it should be surface dry for about 4 hours, re coated after 12 hours, and then dried after 15 hours; for wood with heavy oil content, the drying time will be prolonged when the temperature is low and wet.
提前進行防止開裂變形的措施,濟南防腐木廠家建議將防腐劑涂抹在木材表面,可以防止木材在惡劣的環境下的病蟲的侵襲,繼而延長木材的使用壽命,使用阻止水分滲透功泉州防腐木木屋效比較好的防腐劑,定然起到好的效果。
In order to prevent cracking and deformation in advance, Jinan anti-corrosion wood manufacturers suggest that preservatives should be applied on the surface of wood, which can prevent the invasion of diseases and insect pests in the harsh environment, and then extend the service life of wood. The preservatives with better effect in preventing water penetration in Quanzhou anti-corrosion wood house will certainly have a good effect.
濟南防腐木產品如放置地點、陽光照射、木質因雨淋等自然現象所形成的濕度等易造成變形和開裂。對自然條件我無法改變,防腐木產品開裂和變形會受其他多種因素影響。但是可以在施工中加以控制防止,防腐木成品的外泉州防腐木木屋表是質量最可靠、性能最泉州防腐木木屋好的局部,所以應盡可能的減少對防腐木廢品進行打磨和剖面。這樣可以有效的減少和延緩變形和開裂的時間周期。
Jinan antiseptic wood products, such as the location, sunlight, humidity caused by natural phenomena such as rain, are easy to cause deformation and cracking. I can't change the natural conditions. The cracking and deformation of antiseptic wood products will be affected by many other factors. However, it can be controlled and prevented in the construction. The exterior Quanzhou antiseptic wooden house surface of antiseptic wood products is the most reliable part with the best quality and performance. Therefore, polishing and profiling of antiseptic wood waste products should be reduced as far as possible. This can effectively reduce and delay the time period of deformation and cracking.
濟南防腐木維護,由于水性涂料有著較強的滲透性,所以在上色方面,可以非常好的起到上色的作用,那么何時涂刷作用才非常好呢?主張防腐木木屋在施工完成后的半年左右,防腐木的防腐劑簡直蒸防腐木木屋發結束(在半年后),這樣可以有用的滲透和上色。
Jinan anticorrosive wood maintenance, because the water-based coating has a strong permeability, so in the coloring, it can play a very good role in coloring, so when the brushing effect is very good? It is advocated that the preservative of anticorrosive wood is almost steamed after half a year after the construction of anticorrosive wood, so that it can be used for penetration and coloring.